0.12-1.5 mm DX51D+Z60 Z275 galvanized steel coil မြန်မာ

Zinc Coating Surface Finish

The following surface finishes may be ordered to suit specific end-use requirements:

1. Normal or Regular Spangle

This finish is obtained during normal solidification of a hot-dip zinc coating on steel sheet, and results in the formation of a coating which exhibits either no spangle or zinc crystals of different sizes and brightness depending on the galvanizing process and conditions. If the end user require a heavier coating (Z450 or Z600), there is a distinct tendency for the coating to develop very visible sag lines and ripples that results in a rough surface. However, the solidified zinc appearance has no effect on either the quality or corrosion resistance of the coating. Normal or Regular spangle is supplied for a wide range of applications where over-painting for maintenance purposes may be undertaken at a later stage.

2. Flattened Minimized Spangle

This zinc coating finish is obtained by restricting the normal zinc crystal growth followed by the application of a skin pass process. The zinc coating thus obtained has improved formability and the zinc surface serves as an excellent base for pre-painting, post – painting and powder coating applications. This finish is recommended for applications where a high gloss paint finish is required. It is available for zinc coating of mass up to Z275, and a maximum material thickness of 1.20 mm if passivation is required, or a maximum thickness of 1.60 mm if passivation is not required.

1. Fast delivery time

2. Best price

3. Strong product supply chain

4. Convenient shipping conditions

Roof and Facade Systems

Pipe & Profile

Heating and Cooling , Air Conditioning Systems

Ceiling and Floor Systems

Greenhouse Cultivation

Storage and Shelving Systems